There is a farmer in China: “Spring farming is not willing to be busy, and the face is hungry after autumn.†At present, it is the busy season of spring ploughing. The tiller is an essential agricultural implement for the busy season of farmers, but the farmers are injured during the use. It is not uncommon, this is mainly caused by the irregular operation of farmers. So which operations are not safe during use? How to avoid it?
First, before the operation and use, you must first read the instructions, strictly follow the instructions of the instructions for running-in maintenance, and secondly, must be trained to operate.
2. Check whether the fasteners of the machine are fastened before operation. Remember to tighten the bolts (including the moving box part, the pressure box part, the engine support coupling part, the engine muffler, the air filter, etc.).
Third, the machine head, the fuselage placed in a horizontal position to check whether the addition of engine oil, gear oil, can not be added, can not be added less; check for oil leakage (oil, diesel, gear oil) phenomenon, can be used. Also remember that the fuel tank can not be added with gasoline, you must add 0 # diesel.
4. Before use, add 1cc of engine oil to the bottom of the air filter. At the same time, pay attention to the operation of the micro tillage machine after drinking. The new machine is not allowed to work under heavy load. The field transfer should be changed tires. Especially the work on the slope should prevent the tiller from dumping. Injury.
5. When starting, be sure to confirm the front, back, left and right, and start after safety to avoid injury. When the engine is not started well in winter, the kettle can be started normally by boiling water or pouring 0.5-1cc oil into the combustion chamber.
6. During the operation, change people in the middle, talk with people, and remove the weeds around the knife holder. Do not grasp the clutch in the case of hanging gears. Be sure to confirm that the machine does not advance or is turned off when the machine is in neutral.
7. When the micro tillage machine is installed on the tool holder, do not walk on the concrete road or the slate floor. When working, try to avoid collision with hard objects such as large stones to avoid damage to the blade. After the engine or the traveling box and the pressure box are abnormally sounded, it is necessary to stop the inspection and work after the fault is eliminated.
8. If the operator is less than 1 meter away from the side of the rim during the operation, it is forbidden to use the reverse gear.
9. After the new engine is working on 20 mu of land, the engine must be replaced with oil and gear oil. Otherwise, the cold machine can not drain the residual oil in the machine; after 80-100 mu, it will be replaced for the second time; after 3 to 5 days of continuous operation, it must be Clean the air filter, after 400-700 mu, check the oil pump, nozzle pressure check, valve clearance, and replace the piston ring, valve and connecting rod when necessary.
10. After the completion of each season, you should pay attention to remove the dirt, weeds, oil and other attachments on the tiller, and check the fastening bolts and find the film or other things to prevent the sun and rain. Rusty. (single wave)
Dead Body Freezer,Mortuary Cabinets,Hospital Corpse Freezer
Medsinglong Medical Equipment Co., Ltd. , http://www.gzultrasound.com