Technical Measures for Safe Operation of Combine Harvester

1. The crew shall prepare necessary maintenance tools and vulnerable spare parts and place them in special boxes. The special person shall be responsible for the management. 2. Each unit should be equipped with sufficient and effective fire extinguishing equipment, such as sandbags, fire extinguishers, fire extinguishing hooks, etc., and be placed in an easily accessible place. The exhaust pipes of combine harvesters, tractors, and transport vehicles must be cleaned of carbon deposits and fitted with fire caps. Regular inspections should be performed to remove the accumulated material. The exhaust pipe should be short. 3. The protective cover and cover of the drive chain and drive belt of the combine harvester shall be complete and reliable; the escalator guardrails, handrails, and pedals of the control console shall be installed securely; 4. If you work at night, there should be sufficient lighting equipment in order to find faults at any time. At night, the plots should be flat and free from obstacles, plants not lodging, low humidity and few weeds. 5. If two units are operating at the same time, they should choose different operation areas to avoid collision accidents. 6. Personnel temporarily assigned to the crew should not be changed frequently. Technical training must be conducted prior to the work to master the skills. Otherwise, they cannot participate in the work. 7. The personnel working at night must rotate in two shifts to ensure that the crew has enough sleep and rest time. 8. It is absolutely forbidden for people to lie down in the work area. 9. Specifies the contact signal in the unit operation. There are signal horns, horns, signal flags, etc. All personnel should memorize the signal content. 10. Before working in the field, check whether the technical status of the various parts of the machine is normal. 11. Traction combine harvester, when connecting, personnel can not enter from the side of the harvesting table, and the tractor should be connected from the left side. 12. Before the harvester is started, it is necessary to shake the parts of the transmission by hand and make sure that there is no obstacle before starting. At the same time, put the clutch in the disengaged position, put the self-propelled shift lever in the neutral position, and place the engine reducer in the disengaged position. When shaking the starter handle, only crank the crank halfway from the bottom up. Do not shake it for a while to prevent injury.

Q-switched ND:YAG Laser System

Laser Tattoo Removal,Tattoo Removal,Tattoo Machine

Lasy Science & Technology Co., Ltd. , http://www.ywelightmachine.com

Posted on