1, smart cylinder. In winter, the water blocking ring becomes brittle due to the cold weather, and it is easily broken when installed on the cylinder liner. Before installation, the water stop ring can be soaked in warm water of about 60°C for 5 minutes. After the removal, the installation is not easy to break.
2. Cleverly mounted rolling bearings. When installing the rolling bearing, knocking directly with a hammer can easily deform the bearing and affect its service life. A simple installation method is now introduced: Select a 600 watt bulb to be connected to a power supply, and use it to heat the bearings to be installed. The heating time is 5 to 10 minutes. The heating temperature is maintained at about 110°C. Do not exceed 120°C. Quickly install the bearing on the shaft.
3, clever repair clutch pedal. After the crossover of the clutch pedal is flattened, when the pedal is pressed, the foot easily slides out. Rainy days are easy to slip. If a suitable length of rebar is welded on both the upper and the lower side of the pedal, the rebar plane will be 5 mm above the pedal plane so that it will not slip when used.
4, Qiaozhi tire leaks slowly. Take two tablespoons of talcum powder, pull off the valve core, put away the air inside the tube, use a piece of hard paper to make a funnel, and pour talc into the inner tube. Then fill the valve core with sufficient gas, talcum powder in the tire was diffusely attached to the inner wall, you can block the small air leakage.
5, in addition to fine filter dirt. The dirt and dirt in the rotor oil filter cannot be easily removed. If a layer of paper is applied to the inner wall of the rotor with butter, and the soil is attached to the paper, the paper can be removed and the soil can be completely removed.
6, smart check parts crack. Put the parts into the kerosene, remove them over a period of time, dry the surface and sprinkle with a layer of white powder, then tap the parts with a small hammer. If there is a crack, the kerosene that has been immersed in the cracks will Cracks ooze out and cracks appear on the white powder.
7, demolition old cylinder liner. Use the old old piston pin to install the old piston of the machine, install one or two old piston rings on the old piston, and use a small steel bar with a diameter of 6.50 mm to hook the old piston pin and insert the piston into the cylinder. When the piston ring exceeds the lower edge of the cylinder liner, it will automatically pop open and hold the cylinder liner. At this time, the small steel bar is wrapped around the wooden stick, and then the wooden sleeve is lifted to remove the missing sleeve.
Distal Femur Locking Plate,Tibial Platform Plates,Tibial Implant Plate,Tibia Locking Plate
Jiangsu Health Medical Technology Development Co., Ltd. , https://www.medicalhos.com